Viavi T-BERD MTS 5800 Quick Card page 3

Launch and Configure Test:
1. Press the Power button
test set.
2. Using the Select Test menu, Quick Launch
menu, or Job Manager, launch an Ethernet,
Layer 3 Traffic, IPv4, Terminate test on port
1 for the desired physical interface.
For example:
Ethernet►10/100/1000►Layer 3 Traffic
►IPv4►P1 Terminate.
3. If the test is not in the default setup, tap
the Tools icon , and select
.
Press to continue and wait for
test to reconfigure.
4. For 10/100/1000 Electrical and 1GigE
Optical tests, tap the Ethernet tab of the
Quick Configuration menu and set Auto
Neg. to the same value as the Ethernet port
under test.
5. For 1GigE, 10GigE, 25GigE, 40GigE, or
100GigE optical tests, select the Laser tab in
the Actions panel, and press
button will turn yellow and be relabeled
.
6. Press the Restart soft key
right side of the screen.
7. A green Signal Present LED
T-BERD/MTS is receiving an optical signal
from the port under test. Green Sync
Acquired and Link Active LEDs indicate that
the T-BERD/MTS has successfully connected
to the port under test and the link is active.
to turn on the
. The
, on the
●
indicates the
VIAVI Solutions