Viavi T-BERD MTS 5800 Quick Card page 2

• To inspect SFP ports with the P5000i, insert the probe tip
into the SFP port, move the focus wheel all the way to one
end, and slowly move the focus wheel to the other end.
• To inspect SFP ports with the FiberChek Probe, manually
focus with middle toggle switch or pull the trigger to auto-
focus.
•
If a fiber stub (a darker circle on a lighter background as
shown in figure 3) is detected, follow standard inspection
and cleaning procedures. If you are unable to focus on a
fiber end face, do not clean the port. The SFP contains a
lens and cannot be cleaned.
Connect to Line Under Test:
1. For copper 10/100/1000BASE-T
testing with the T-BERD/MTS
5800v2, connect the Port 1
10/100/1000 RJ-45 jack to the port
under test using CAT 5E or better
cable.
2. For copper 10/100/1000BASE-T
testing with the T-BERD/MTS 5800-
100G, insert a copper SFP into the
Port 1 SFP+/SFP28 slot and connect
to the port under test using CAT 5E
or better cable.
3. For optical interfaces:
• Insert desired SFP, QSFP, or
CFP4 into the Port 1 slot on the
top of the T-BERD/MTS.
• Inspect and, if necessary, clean
all SFPs, fibers, and bulkheads,
as described on page 1.
•
Connect the SFP, QSFP, or CFP4
to the port under test using a
Single Mode or Multimode
jumper cable compatible with
the interface under test.
Figure 3: Image of Clean Fiber
Figure 4: T-BERD 5800v2 Dual Port mainframe
Figure 5: T-BERD 5800-100G mainframe
VIAVI Solutions