Operating Safety - Wallenstein GX620 Operator's Manual

Mounted backhoes
Hide thumbs Also See for GX620:
Table of Contents

Advertisement

2.6 OPERATING SAFETY

1. Please remember it is important that you read
and heed the safety signs on the Backhoe.
Clean or replace all safety signs if they can-
not be clearly read and understood. They are
there for your safety, as well as the safety of
others. The safe use of this machine is strictly
up to you, the operator.
2. All things with moving parts are potentially
hazardous. There is no substitute for a cau-
tious, safe-minded operator who recognizes
potential hazards and follows reasonable
safety practices. The manufacturer has
designed this Backhoe to be used with all
its safety equipment properly attached, to
minimize the chance of accidents. Study
this manual to make sure you have all safety
equipment attached.
3. If a safety shield or guard is removed for any
reason, it must be replaced before the ma-
chine is again operated.
4. Always use the drawbar anchor bracket when
mounting a Backhoe to tractor. Adjust to pre-
vent Backhoe from moving when digging.
5. Attach the tractor side plate to reinforce the
frame if required. Do not overload the tractor
frame.
6. Do not use a "Quick Hitch" on the 3 point
hitch.
7. Review maps of underground utilities before
starting to dig. Remove all sticks, stones,
roots, and wires from working area before
starting. Take care not to contact overhead
and underground obstructions during opera-
tion.
8. Never operate controls from the ground. Op-
erate only from the operator's seat to prevent
unexpected boom movement that can lead to
crushing between frame members.
9. Do not dig under machine or stabilizers. A
cave-in could result and the machine could fall
into the excavation.
10. Lower stabilizers to the ground to support
machine befoe starting to dig.
11. Keep boom and bucket away from overhead
and underground power lines. Electrocution
can occur without direct contact with an over-
head power line.
12. Do not exceed machine lift capacity. Over-
loading can cause structural damage and lead
to unsafe operating conditions.
13. Position Backhoe so that loads extend directly
behind machine when lifting or placing heavy
objects.
14. Counter-balance backhoe with suitcase
weights or a loader to provide stability. Unbal-
anced machines can tip during operation.
15. Never carry, lift or move people on boom or
bucket.
16. Always use two people to handle heavy, un-
wieldy components during assembly, installa-
tion, removal or moving.
17. Never place any part of your body where it
would be in danger if movement should occur
during assembly, installation, operation, main-
taining, repairing, removal or moving.
18. Do not walk or work under a raised machine
or attachment unless it is securely blocked or
held in position. Do not depend on the tractor
hydraulic system to hold the machine or at-
tachment in place.
19. Never use alcoholic beverages or drugs which
can hinder alertness or coordination while
operating this equipment. Consult your doc-
tor about operating this machine while taking
prescription medications.
20. Do not allow riders on this machine at any
time. There is no safe place for any riders.
21. Before you operate the machine, check over
all hydraulic lines, hoses, connections and
components. Replace any worn or damaged
parts immediately. Tighten all leaking fi ttings.
22. Keep hands, feet, hair, jewelry, and clothing
away from all moving and/or rotating parts.
23. Review safety instructions annually.
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gx720Gx920Gx920 xt

Table of Contents