Introduction; Layout (Fig.1-2); Scope Of Delivery - Toolson HRB1700 Translation Of The Original Instruction Manual

1. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
Important:
When using electric tools safety precautions should
always be followed to reduce the risk of fire, electric
shock and personal injury including the following.
Read all these instructions before attempting to op-
erate this product and save these instructions. Keep
this manual in a safe place, so that the information is
available at all times. If you give the equipment to any
other person, hand over these operating instructions
and safety regulations as well. We cannot accept any
liability for damage or accidents which arise due to a
failure
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country. Keep the operating instructions pack-
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture. Read
the instruction manual each time before operating the
machine and carefully follow its information. The ma-
chine can only be operated by persons who were in-
structed concerning the operation of the machine and
who are informed about the associated dangers. The
minimum age requirement must be complied with.
We assume no liability for accidents or damages
resulting by disregarding these instructions and the
safety instructions.
2. Layout (Fig. 1-2)
1. Handle
2. Spray-lance
3. Upper holder spray-lance
3a. Holder spray-nozzles / high pressure hose
4. Nozzle Extension with Quick Connect
5. Cover air filter
6. Wheels
7. Lower support spray-lance
8. Stand
9. Housing Exhaust
10. Spark plug connector
11. Fuel cap
11a. Fuel Tank
12. Spray nozzles
13. Flexible high pressure hose
14. Safety lock spray-lance
15. Trigger spray-lance
16. Run / Stop Switch
17. Connection suction hose for detergent
18. High Pressure Hose Connection
19. Water Inlet (external)
20. Oil cap with oil dipstick
21. Spark plug
22. Reversing starter
23. Chemical Injection Siphon/Filter
24. Air Filter

3. Scope of delivery

Main unit
Handle
High pressure hose
Spray-lance
Extension spray-lance
Spray-nozzles
Wheels
Stand
Lower support spray-lance
Upper holder spray-lance
Holder spray-nozzles
Chemical Injection Siphon/Filter
Bag with small parts
Manual
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, store the packaging until the warranty
period has expired.
m Attention!
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
(1x)
(1x)
(1x)
(1x)
(1x)
(5x)
(2x)
(1x)
(1x)
(1x)
(1x)
(1x)
(1x)
(1x)
GB | 25