Table of Contents
Advertisement
EXTRACTION GUIDE
2
Once the upper section is
removed, place the two wooden
studs in the pivot base. Make sure
they exceed of approximately 10"
(25 cm).
3
Lift the end of the studs, insert
a wooden block in the gap
underneath the studs and drop the
studs on the wooden block.
Screw the studs into the pivot.
Leave the wooden block in place.
2.1
3.1
3.2
3.3
- 3 -
Advertisement
Table of Contents
Need help?
Do you have a question about the probase01 and is the answer not in the manual?
Questions and answers