Advertisement
Time Switch
Programme the chlorinator timer to turn on or off at any time that suits your lifestyle.
The Time Switch controls power to the Chlorinator controller.
Electrolytic Salt Cell
The Hydrochlor TS
®
's salt cell consists of a series of
titanium electrodes with opposite charges. Hydrochlor
TS
®
's clear salt cell housing allows visual inspection of
the salt cell plates and enables monitoring of chlorine
production.
The cell housing is constructed using clear U.V. stabilized acrylic.
Both anode and cathode of the self-clean chlorinator are made from uniquely coated
titanium plates for extra durability.
Self-Cleaning
Hydrochlor TS
®
Self Clean Salt Cell has the added ability to reverse the polarity of
the voltage to clean calcium build up off its electrodes.
The Hydrochlor TS
's electrodes, the anode and cathode and hold an electrical
®
potential difference between them for a designated period of time. This difference
is reversed after that period of time has expired and then the anode becomes the
cathode and the cathode becomes the anode.
The reversing of polarity or electrical potential difference will then start to remove
any calcium build-up, which may have been deposited onto the cathode.
This continuous reversing of polarity will keep the cell clean from calcium deposits
during its operation, providing the chemical balance and flow of the pool water thru
the cell is maintained within normal parameters.
It is recommended that you obtain regular water chemistry tests from your local
pool professional to ensure your water balance is within range.
Battery Backup
The Time Switch comes with a a super capacitor incorporated to save your settings
in the event of a power failure. The super capacitor requires 70 hours of continuous
power supply to achieving a full charge.
The time switch specifications are the following:
Super Capacitor Charge Time: 70 hours.
Super Capacitor Power Reserve: 150 hours.
INSTALLATION
These guidelines should be followed to install the Hydrochlor TS
a. Ensure that the chlorinator cell is the last piece of equipment installed on
the filtration system – this is so the chlorine produced will not damage other
equipments such as heaters.
b. The cell may be installed above or below water level. If it is below water level,
please ensure that an isolation valve is installed so the unit can be serviced
without losing water from the pool.
c. The cell may be mounted on different angles so long as a gas trap is provided.
GAS TRAP: The cell must be positioned in such a way as to provide a gas trap. The
bottom of the cell must be above the top surface of the pipe from the previous
piece of equipment, as per the below diagram.
Waterco Hydrochlor TS
®
I pg 03
®
:
GAS TRAP
40/50mm glued
connections
Sell Clean Requires
Minimum Maintenance
Advertisement
