Installation
FBI (Fully Built-In) models
Ø2
20
English
DW9000M_DD68-00193B-02_EN.indd 20
A
B
C
B
C
1. Insert the supplied rubber skirt (A) into
the 3 holes at the bottom of the door.
(applicable models only)
2. Put the installation template on the
back of the custom panel and fix it
temporarily using transparent tape.
Note that the rear of the custom panel
will be attached to the dishwasher door.
CAUTION
• The top end of the custom panel must
be aligned with the top end of the
installation template.
• Use a custom panel between 4 kg and
9 kg.
3. Mark 6 points guided on the installation
template.
4. Remove the installation template and
tighten the custom panel fixers (B) at
the top with 2 screws (C, Ø4 X 16) as
shown.
2018-04-10
12:58:55