LG OLED55GXPUA Owner's Manual page 10

Securing TV to the Wall
(Except for OLW480B)
Please use the TV close to the wall after installation.
How to x anchors and screws
(Except for OLW480B)
Please make sure that:
Check that the material and thickness of the wall and nishing
material comply with the installation manual.
Use the enclosed anchors and screws on crack-free concrete walls.
___________________________
Never install the product on a wood stud, plasterboard or wall
Incorrect >
The
made of paper or medium-density berboard (MDF). When it
recommended
is necessary to install the product on such wall, anchor screws
wall to install the
must be fastened to retaining walls (concrete) inside the nishing
GX is on a wood
material, and if there are no retaining walls, anchor screws must be
studded wall.
fastened after a separate hanger is installed.
Other unspeci ed walls must be capable of supporting pullout
loads of over 70 kgf (154 lbf) (686 N) and shear loads of over
100 kgf (220 lbf) (980 N) per fastener.
Use a Ø 8 mm (0.31 inches) drill bit and hammer (impact) drill for
concrete.
Value Electronics
Authorized LG Dealer
www.ValueElectronics.com
10
1 Drill holes in anchor locations with a drill bit of Ø 8 mm
(0.31 inches) to a depth of 80 mm (3.15 inches) to 100 mm
(3.94 inches).
2 Clean the drilled holes.
3 Insert the enclosed anchors for xing the wall mount into the
holes. (Use a hammer when inserting anchors.)
Wall mounting anchor
4 Push the wall mount support closely toward the wall to match
the hole locations.
5 Tighten screws for xing the wall mount to the holes. At this
time, tighten the screws to a torque of between 45 kgf/cm
(39.06 lbf/in) to 60 kgf/cm (52.08 lbf/in).
Wall mounting screw