Penton RCS6/FTS Installation Instructions

Slide Plate
"A"
1. Loosen wingnut "A"
(you will NOT have to remove the
wing nut completely)
2. If the wingnut is on e.g. your left,
slide the whole plate to the left.
6. Re-fit plate to dome and
tighten wingnut
9. Fitting the speaker
Compress "V" spring and fit into
the retaining ear within the dome.
Connect leads to the speaker
transformer.
Penton UK Ltd, Unit 2, Teville Industrials, Dominion Way, Worthing, West Sussex BN14 8NW
Tel: 01903 215315 Fax: 01903 215415 E-Mail: sales@pentonuk.co.uk Web: www.penton.org
ROUND METAL CEILING LOUDSPEAKER
Installation instructions
Slide Plate out
3. This will disengage the retaining clip "B"
4. Lift the plate slightly @ "B" and slide
the plate right until clear of the dome.
Slide
Fitting the dome into a ceiling
7. Loosen the retaining knob for slider "C"
Push sliders to the top of the dome and
insert dome into pre-cut hole.
10. Fit second "V" clip into second
retaining ear and gently push the
speaker up into the dome (do not
push the central perforated grille area)
the speaker will self locate into the dome.
RCS6/FTS
"B"
"C"
5. Wire plate
8. Once dome has been inserted pull
the slider knob down until it clamps to
the ceiling. Tighten the retaining knobs
to secure the dome.
Circuit Diagram
100V COM
O O
X
0.25W
0.75W
1.5W
3W
6W
Hole cutout
RCS6FTS 200mm
Issue 2 May 2007