Neilsen CT0957 Original Instructions Manual page 9

6.3 Adjusting the height

The correct height can be set by unlocking the clamping knob (8) and
turning the knob for the height adjustment (9) to the desired height with
aid of the scale (10)

The height must corresponds to half of the material thickness of the work
piece, the groove lot the biscuit dowel must always be in the middle of the
working piece
6.4 Checking the cutting depth

Always check the cutting depth after mounting a saw blade.

Disconnect the plug from the socket.

Move the motor base (14} as far as possible backwards.

Set the cutting depth in the maximum position by turning the depth
adjustment knob (6).

Move the motor base forwards till the pin will fall in the notch of the
adjustment knob (6)

Turn the saw blade till one tooth of the saw blade is in the front position.

Measure the distance from the side of the base plate to the tooth of the
saw blade.

Check if the distance is 19mm. The maximum position is 18mm.
6.5 Setting the cutting depth

When the cutting depth is not correct, it can be adjusted as following:

Move the motor base (14) as far as possible backwards

Loosen the Pin

Set the cutting depth by turning the screw, the screw is positioned at the
back of the pin.

Repeat the procedure till the cutting depth is correct.

Fasten the Pin.
7. ASSEMBLY
ATTENTION! Disconnect the power plug before carrying out any
adjustments or maintenance.