Table of Contents
Advertisement
BMMTRS1
ENGLISH
3.2.9 NCV (Non-Contact Voltage detect)
Set rotary switch to the ACV / EF- range, Press the SELECT key to go NCV detect mode. Put
the EF-DETECT AREA close to the AC power cable or the power socket, if AC electrical voltage is
The lowest detect voltage is around 50V 50/60Hz.
The LCD display EF, when detect the AC voltage signal, the LCD display ' - '/' -- '/' --- '/' ---- ' from
weak to strong.
This function is depending model.
3.2.10 PC Link
measured data can be recorded, analyzed, processed and printed by PC. Before use this function,
Keep press REL
Auto power off function is disabled when PCLINK function active.
successfully installed before any measurement.
3. Run the PC-LINK software, click the Start button.
4. Keep press REL
the LCD if the serial data output function is active.
these steps:
5. Now the PC-LINK SOFT view the synchronic data or graph in the software interface.
6. To disable the PCLINK function, Keep press REL
4. TECHNICAL SPECIFICATIONS
Environment conditions:
1000V CAT III and 600V CAT IV
Pollution degree: 2
Altitude < 2000 m
MAX. Voltage between terminals and earth ground: 1000V AC rms or 1000V DC.
Fuse Protection: μA and mA: F 0.63A/1000V Ø
Sample Rate: 3 times/sec for digital data.
Display: 3 5/6 digits LCD display. Automatic indication of functions and symbols.
key more than 2 seconds.
10.3x38.
15
Advertisement
Table of Contents
