Ncvhef; Pc Link; Technical Specifications; General Specifications - Bahco BMMTRS1 Original Instructions Manual

BMMTRS1
ENGLISH
3.2.9 NCV (Non-Contact Voltage detect)
Set rotary switch to the ACV / EF- range, Press the SELECT key to go NCV detect mode. Put
the EF-DETECT AREA close to the AC power cable or the power socket, if AC electrical voltage is
present, the Buzzer warning will sound, and the symbol bar "-" will be displayed on the LCD.
The lowest detect voltage is around 50V 50/60Hz.
The LCD display EF, when detect the AC voltage signal, the LCD display ' - '/' -- '/' --- '/' ---- ' from
weak to strong.
This function is depending model.

3.2.10 PC Link

The meter has serial data output function. It can be connected with PC by USB interface, so the
measured data can be recorded, analyzed, processed and printed by PC. Before use this function,
you need install the PC-Link software and USB driver in your PC.
Keep press REL r more than 2 seconds and the meter enter PC-Link mode, the symbol "PC-
LINK" will appear on LCD, and the serial data output function is active.
Auto power off function is disabled when PCLINK function active.
PC-LINK SOFT OPERATING MANUAL
1. Make sure the two Install USB driver and Install software/RUN files in the attached USB stick
successfully installed before any measurement.
2. Connect the meter's OPTICAL PORT and computer USB port with the USB cable.
3. Run the PC-LINK software, click the Start button.
4. Keep press REL r
the LCD if the serial data output function is active.
As for check the USB cable success recognized, we can view it in the Device Manager by following
these steps:
• Right-click the My Computer icon on the Windows desktop, and then click Properties.
• Click the Hardware tab and then click Device Manager.
• Scroll through the list of installed devices till you locate the Ports (Com and LPT) entry. Click the
plus (+) beside this entry to view the installed ports, If no errors occur, the USB to Serial COM
Port (COM x) will appear, COM x is just the proper port, here x is a specific number.
5. Now the PC-LINK SOFT view the synchronic data or graph in the software interface.
6. To disable the PCLINK function, Keep press REL r key more than 2 seconds.

4. TECHNICAL SPECIFICATIONS

4.1

General specifications

Environment conditions:
1000V CAT III and 600V CAT IV
Pollution degree: 2
Altitude < 2000 m
Operating temperature: 0~40°C, 32°F~122°F(<80% RH, <10°C non-condensing)
Storage temperature: -10~60°C, 14°F~140°F(<70% RH, battery removed)
Temperature Coefficient: 0.1x(specified accuracy) / °C (<18°C or >28°C)
MAX. Voltage between terminals and earth ground: 1000V AC rms or 1000V DC.
Fuse Protection: µA and mA: F 0.63A/1000V Ø 10.3x38; A: F 10A/1000V Ø 10.3x38.
Sample Rate: 3 times/sec for digital data.
Display: 3 5/6 digits LCD display. Automatic indication of functions and symbols.
key more than 2 seconds on the meter, the symbol "PC-LINK" will appear on
15