Advertisement
2 Channel Radio Interface
Each button on a hand held transmitter, when pressed, transmits a different
code. Pressing a combination of buttons on a hand held transmitter will also
transmit another different code. It would then be possible to have a two
channel hand held transmitter controlling three different functions.
Transmitter Button(s) Pressed
For example, you could have button 1 (Code 1) for arming and disarming the
system in AWAY mode. Button 2 (Code 2) could be used to operate Relay 1
(to control the garage door). Both buttons held down together (Code 3) could
be used to generate a PANIC alarm.
The above example uses three remote radio user codes. There are 120 remote
radio user codes available in the receivers memory.
The following table outlines the switch combinations that need to be held down
whilst teaching transmitter codes to the receiver to operate the different
functions of the receiver.
An
denotes the switch/s to be held down for each operation required.
Operation Required
AWAY Mode
Arm Only
AWAY Mode
Disarm Only
Arm/Disarm In AWAY
Mode
Arm/Disarm In
STAY Mode
Panic Alarm Via
Transmitter
Operate Relay 1 With
Momentary Operation
Operate Relay 2 With
Momentary Operation
Operate Relay 1 With
Toggle Operation
Operate Relay 2 With
Toggle Operation
Bosch Security Systems Pty Limited
Button 1
Button 2
Buttons 1 and 2 Together
Switch 1
Switch 2
Page 3
Code Transmitted
Code 1
Code 2
Code 3
Switch 3
Switch 4
ISSUE100.DOC
Advertisement
