Input labeling example:
The screen below left shows the default Input Selection
screen (with none of the inputs labeled as a specific device).
The screen below right is an example of how you could label
the inputs if you connected a VCR to VIDEO 1, Cable TV to
VIDEO 2, a video recorder to ColorStream HD1, and a DTV
set-top box to HDMI. Also note that the ColorStream HD2
input is labeled "Hidden," which means that input will be
skipped over when + is pressed.
Input Selection
ANT 1
0
ANT 1
ANT 1
1
Built-In DVD
2
Video 1
3
Video 2
4
ColorStream HD1
5
ColorStream HD2
6
HDMI
7
PC
0
-
7
/
INPUT
to Select
Input Selection screen with
no inputs labeled.
To clear the input labels:
1
Press Y and open the Preferences menu.
2
Highlight Input Labeling and press T.
3
Highlight Reset and press T.
24
Chapter 5: Using the TV's features
Input Selection
ANT 1
0
ANT 1
ANT 1
1
Built-In DVD
2
VCR
3
Cable
4
Video Recorder
5
ColorStream HD2 (Hidden)
6
DTV
7
PC
0
-
7
/
INPUT
to Select
Input Selection screen with
all inputs labeled except input 5,
which has been hidden.
Tuning channels
Tuning channels using the
Channel Browser
™
™
The Channel Browser
stores the most recently viewed
channels or inputs in a history list. In addition, it provides a list
of all the available channels on the ANT1 input (up to 2000),
plus a list of all the inputs on the TV. This feature allows you
to:
Keep a history of the last 32 channels or inputs viewed.
•
Quickly surf and tune your recently viewed channels/inputs
•
from the Channel Browser
page).
Surf via Browse mode (to immediately tune channels as you
•
highlight them in the Channel Browser
mode (to surf over channels in the Browser banner before
you select one to tune).
Quickly change inputs from the Inputs List.
•
Set a "HOME" source for an ANT1 channel or TV input.
•
To set up the Channel Browser
1
Press Y and open the Preferences menu.
2
Highlight Channel Browser Setup and press T.
3
Press B to highlight Navigation, and then press C or c
to select either Browse Mode or Select Mode.
Channel Browser Setup
Navigation
History List
ANT1 List
Inputs List
Reset
4
Press b to highlight History List, and then press C or c
to select the setting you prefer: either Power Off Clear
(On), On, or Off.
Note: When History List is set to On, the channels and
inputs stored in the list will be saved every power on/off
cycle. When History List is set to Power Off Clear (On),
the channels and inputs stored in the list will be cleared
with every power on/off cycle of the TV.
5
Press b to highlight ANT1 List, and then press C or c to
select On or Off.
6
Press b to highlight Inputs List, and then press C or c
to select On or Off.
7
To save your entries, highlight Done and press T.
To return to factory defaults, highlight Reset and press
T.
™
banner (illustrated on the next
™
banner) or Select
™
:
Select Mode
Power Off Clear (On)
On
On
Done