Scope Of Delivery; Placing The Device In Operation; Switching On/Off; Volume - Blaupunkt NEW YORK 800 Operating Instructions Manual

Scope of delivery | Startup | Radio mode

Scope of delivery

The scope of delivery includes:
• New York 800
• Remote control (incl. battery)
• TMC Tuner (for 1 011 103 800/802/810/812 only)
• MicroSD card with navigation data in the MicroSD
card slot (only for devices with navigation)
• GPS antenna (for 1 011 103 800/802/810/812 only)
• External Bluetooth microphone
• Getting started
• Support frame
• Small parts set
• Installation material
• Connecting cable

Placing the device in operation

Caution!
Transport securing screws
Ensure that the transport securing screws are removed
before the startup of the device.

Switching on/off

Switching on/off with the rotary/pushbutton
u For switch-on, press the rotary/pushbutton
u For switch-off , hold the rotary/pushbutton
pressed for more than 2 seconds.
Switching on/off via vehicle ignition
If the car sound system is connected with the vehicle
ignition and it was switched off with the rotary/pushbut-
5
ton , it is switched on or off with the ignition.

Volume

Adjusting the volume
You can adjust the volume in steps from 0 (off ) to 50
(maximum).
u Turn the rotary/pushbutton
ume.
Muting the car sound system (Mute)
u Briefl y press the rotary/pushbutton
device or to reactivate the previous volume.
6
5
.
5
5
to change the vol-
5
to mute the

Main menu

In the main menu, you press the buttons on the touch-
screen to call up the diff erent sources and operating
modes.
u Press the MENU button
The main menu is displayed.
As long as you do not select a new audio source, the
last active audio source is played back.
Note:
The fi gures used in these instructions are intended
to facilitate the explanations and details may deviate
from your device.

Radio mode

Start radio mode

u In the main menu, press the Radio button.
The radio menu is displayed.

Select memory bank

Diff erent memory banks and wavebands are available.
Up to 6 stations can be stored in each memory bank.
u Press the [
] button repeatedly until the desired
memory bank is displayed.

Tuning into a station

Tuning into stations manually
u Briefl y press the [
eral times to change the frequency in increments.
2
.
] or [ ] button once or sev-