Distance Run Display - JRC JLN-550 Instruction Manual

GPS (It may not be able to be chosen by the specification.)
•
The ground speed that it resolved into the longitudinal and transverse direction of the ship is
indicated from ship speed and course information calculated by GPS receiver.
The part of the BT speed of the output data changes to the speed by GPS.
The connection of the GPS receiver and GYRO is necessary for this indication.
• Reference: Indication for transverse speed at STERN (only in the case of 3 axis specification)
It is indicated in the case of the AUTO/BT mode or forced BT mode and the GPS mode.
The transverse speed of the BOW part and the STERN part can indicate a speed in the position to
specify a vessel.
The input of the rate of turn information of the ship is necessary for this indication.
(The connection of ROT or GYRO)

4.3 Distance run Display

The Distance Run increase per 0.01nm of the Fore speed element only.
Resetting the Trip-Distance
•
Push UNIT and TRIP key of the panel at the same time.
Then, the trip distance counter is reset.
Resetting the Total-Distance
•
Turn on the power switch PWR while long pushing TRIP key. And release TRIP key.
After it rings "Pitsu" at about 1 minute, turn off power.
After a few minutes, the total distance is initialized.
(This operation is complex to protect it from a careless operation.)
4. Operation 21