Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Femco Manuals
  4. Tractor Accessories
  5. WEATHERBRAKE 307022172
  6. Instructions manual

Femco WEATHERBRAKE 307022172 Instructions Manual

Fits agco gt-series
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
INSTRUCTIONS
WEATHERBRAKE
307022172
FITS
AGCO GT-Series
General Offices
1132 W. 1ST STREET
McPherson, KS 67460
Phone: (620) 241-3513
Web: www.femcomfg.com
Form No. 286324100 / 11-2005

Advertisement

loading
Need help?

Need help?

Do you have a question about the WEATHERBRAKE 307022172 and is the answer not in the manual?

Questions and answers

Related Manuals for Femco WEATHERBRAKE 307022172

Summary of Contents for Femco WEATHERBRAKE 307022172

  • Page 1 INSTRUCTIONS WEATHERBRAKE 307022172 FITS AGCO GT-Series General Offices 1132 W. 1ST STREET McPherson, KS 67460 Phone: (620) 241-3513 Web: www.femcomfg.com Form No. 286324100 / 11-2005...
  • Page 2 IMPORTANT CAREFULLY STUDY THE PHOTO DIAGRAMS SHOWING THE LOCATION OF EACH PART. LEAVE ALL HARDWARE LOOSE UNTIL INSTRUCTED TO TIGHTEN. YOKE BRACKETS 1. Remove bolts from dash and attach yoke bracket (A) using same bolts removed. 2. Attach yoke bracket (B) using two (2) 1/4” x 3/4” bolts and nuts 3.
  • Page 3 EXHAUST GUARD 1. Remove bolt and attach exhaust guard (A). 2. Attach exhaust guard (B) using two (2) 1/4” x 3/4” bolts and nuts. 3. Tighten all bolts. MOTOR COVER 1. Arrange motor cover over hood of tractor. 2. Slide 3” hem of motor cover down over top of door post.
  • Page 4 YOKE 1. Insert yoke (A) into top 3” hem of motor cover. 2. Attach yoke to yoke bracket using two (2) 1/4” x 3/4” bolts and nuts 3. Attach yoke to door post using one (1) 1/4” x 1” bolt and nut.

  • Page 5: Windshield Assembly

    TIE STRAPS 1. Thread cloth strap through grommets at bottom of mo- tor cover and tie. 2. Route cloth straps to other side or to a point on tractor and tie. IMPORTANT Cloth straps are not to be attached to any moving, ro- tating, or heat generating points of tractor.
  • Page 6 DOORS 1. Locate holes in door post and cut holes in the fabric. 2. Hold door (A) to door post and bottom of the wind- shield. 3. Mark location of holes in the door post to the door. 4. Cut 5/8” slots next to wire frame of door and attach to door post using four (4) #10 x 3/4”...

  • Page 7: Door Latch

    DOOR LATCH 1. Assemble door latches as shown using two (2) 1/4” x 3/4” bolts and nuts. 2. Position under bottom rear of door. 3. Door is to be set firmly in loop of door latch. Change position up or down with adjustment holes if necessary. 4.