Semtech Asset Tracking Reference Kit User Manual page 4

Setting up the Kit
Gateway Connections
The gateway body has multiple connectors for antennas and cables. The following table describes those
connections.
ANT 1 GPS antenna connector (N-type female)
Ethernet Power-over-Ethernet connector
ANT 2 3G/4G antenna connector (N-type female)
ANT 3 915/868 MHz LoRa antenna connector (N-type female)
3G/4G Access port for 3G/4G SIM card
ANT 4 915/868 MHz antenna connector (not connected)
About the Gateway
The ODU gateway is an 8-channel LoRaWAN-compliant gateway with external antennas. This gateway has
the following features:

Support for LoRa Basics™ Station

Gateway ping

Support for LoRaWAN 1.0.2 or higher

8+ LoRa channels

External antenna (for greater range)

Indoor/Outdoor form factor

Modular support for 3G/4G

Optional features (Not supported out-of-the-box)
o GNSS/precise timing support (for GNSS aiding messages/synchronized downlinks)
o Outdoor mounting support
o IP67 rating for outdoor mounting
Gateway Setup
To set up the gateway, follow the steps below.
Note: Do not connect power until all antenna connections are complete.
Asset Tracking Reference Kit User Guide
Guide
February 2020
semtech.com/LoRa
Page 4 of 21
Proprietary
Semtech