To support you on the installation and repairs of this electric wheelchair, we provide you with this installation manual. Please read it carefully. If you still have questions after reading this manual, do not hesitate to contact Vermeiren. The information in this manual applies to the following wheelchair(s): ...
Forest 3+ 2020-01 Scope of delivery Scope of delivery The following items are part of the delivery: Framework with armrests, operator control, rear and front wheels, seat and backrest (optional: electrically adjustable seat, backrest, electrical lift) Footrests Batteries ...
Read the user manual of this wheelchair. Be aware of the technical details and limits of intended use; see the user manual. For more information, contact Vermeiren. Tools To (dis)assemble and adjust the wheelchair, the following tools are needed: ...
Adjusting the wheelchair to the user 3.2.1 Seat depth The Vermeiren Forest 3+ is adjustable in 6 different seat depths over a range of 100 mm (steps of 20 mm). 1. Loosen the two screws (1) on either side of the frame.
Forest 3+ 2020-01 Assembly and adjustments Maximum seat inclination: 21° Minimum seat inclination: 2° 3.2.4 Armrest length Adjust the length of the armrests as follows (6 positions: steps 20 mm): 1. Loosen the screw (1). 2. Adjust the armrest to a comfortable length. 3.
Forest 3+ 2020-01 Assembly and adjustments 3.2.6 Footrest width 1. Loosen the two screws (A) on the front of the seat frame. 2. Move the footrest in an horizontal direction until the correct seat with, by moving the square tubes (B) and (C) over each other (3 different positions: steps 15 mm on each side).
2020-01 Assembly and adjustments Replace both batteries at the same time and with the same type as the ones used in the wheelchair. If this is not possible, contact the nearest Vermeiren facility. Battery connections: 1) Blow fuse 2) Plug (electronic system)
Forest 3+ 2020-01 Assembly and adjustments 11. Remove grease and other contamination from the thread of the 5 flange socket screws (48). Apply screw adhesive (ex. Loctite) to these screws. 12. Mount the wheel on the flange. 13. Lower the jack. 14.