Connection - Toshiba TDP TDP-S8 Owner's Manual

Connection

Before connection
• Read the owner's manual of the device you are connecting to the projector.
• Some types of computer cannot be used or connected to this projector.
Check for an RGB output terminal, supported signal
• Turn off the power of both devices before connecting.
• The figures are sample connections.
• The MONITOR terminal outputs analog RGB signals or component video signals (Y/P
P ) from the COMPUTER IN terminals as selected with the INPUT button. If no input
R
is selected, the MONITOR terminal outputs the input signals last selected among the
COMPUTER terminals.
• A computer monitor usually cannot accept Y/P
Monitor
Computer
Notes
• Moving pictures played back on computers using DVD software may appear unnatural if
it is projected with this projector, but it is not a malfunction.
• When an AUDIO OUT terminal is connected, sound is not output from the projector
speaker.
• Output volume of AUDIO OUT terminal can be adjusted by the VOL button.
To video
output
AV cable
(not supplied)
S-VIDEO
MONITOR
COMPUTER
RGB cable
AV cable
(not supplied)
(supplied)
To RGB output
To S-video
output
p.42 , etc.
/P signals correctly.
B R
Computer (for control)
To audio
input
Audio cable
(not supplied)
AUDIO IN
CONTROL
VIDEO
AUDIO OUT
Audio cable
(not supplied)
To audio output
22
/
B
p.44
To RS-232C
terminal
Control cable