Names Of The Terminals On The Rear Panel; Preparing And Using The Remote Control - Toshiba TDP TDP-EX20 Owner's Manual

Names of the terminals on the rear panel

(1) (2) (3) (4)
(8) (9)(10) (11) (12)
Name : Main Function
(1) LAN terminal : Connects a network cable.
(2) USB terminal : Connects a commercial USB memory.
(3) COMPUTER 2 IN terminal : Input RGB signal from a computer or other source, or a
component video signal (Y/P
(4) AUDIO IN terminal : Input audio signals from a computer, or from video
equipment with a component video signal output terminal.
(5) COMPUTER 1 IN terminal : Input analog RGB signal from a computer or other source, or
a component video signal (Y/P
(6) AUDIO (L/R) terminal : Input audio signals from video equipment.
(7) VIDEO terminal : Input video signals from video equipment.
(8) AC IN socket : Connects the supplied power cord here.
(9) CONTROL terminal : When operating the projector via a computer, connect this
to the controlling computer's RS-232C port.
(10) Main power switch : AC power line ON (standby)/OFF.
(11) MONITOR terminal : Connect to a computer display, etc.
(12) AUDIO OUT terminal : Outputs audio signals.
(13) AUDIO (L/R) terminal : Input audio signals from video equipment.
(14) S-VIDEO terminal : Input S video signals from video equipment.
(5) (6) (7)
(13) (14)
p.48
/P ) from video equipment.
B R
/P ) from video equipment.
B R
p.96
20

Preparing and using the remote control

Loading dry-cell batteries
into the remote control
Remove the battery cover.
1
Insert the dry-cell batteries.
2
Be sure to align the plus and minus ends
of the batteries properly.
Two batteries (LR03, SIZE AAA) are used.
Replace the battery cover.
3
Dry-cell batteries
• Before using the batteries, be sure to observe the Safety Precautions described in
previous pages.
• Remove batteries from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace all the batteries
with new ones.
• Keep the batteries away from the reach of children.
Batteries are choking hazards and can be very dangerous if swallowed. If the batteries
are swallowed, seek medical assistance immediately.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not get wet or place on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If
this happens, point the remote control at the main unit again, and repeat the operation.
Operating the remote
control
Point toward the projector's infrared
remote sensor, and press a button
on the remote control.
• Operating the projector from the front
Approx. 15°
When operating the remote control
from behind the projector, the signal
beam is reflected on the projecting
surface and may travel a shorter
distance to reach the projector
depending on the shape and material
of the projecting surface.
21