Table of Contents
Advertisement
6-Daily use
6-8
6.11 Interrupt - cancel wash programme
To interrupt a running programme press gently "Start/Pause". Programme run-time is
flashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Press "Start/Pause" button to interrupt the running programme.
2.
3. Run programme SPIN + DRAIN to drain the water.
4. Select a new programme and start it.
Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above); "door is open"-symbol is displayed.
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door; the "door lock"-symbol is displayed.
6.12 After washing
1. At programme cycle end END is displayed.
2.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
Note: Standby mode / energy-saving mode
The switched on appliance will go into standby mode if it will not be activated within
two minutes before starting the programme or at the end of programme. The display
6.13 Activate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the SPIN + DRAIN programme.
3. Press the "I-time "button and "Speed" button at the same time for about three
seconds. "bEEP OFF" will be displayed and the buzzer will be deactivated.
For activating the buzzer press these two buttons at the same time again. "bEEP ON" will
be displayed.
18
6.10 Start wash programme
Press "Start/Pause" button (Fig. 6-8) to start; appli-
ance operates according to present settings. Changes
are only possible by cancelling the programme.
GB
Hide quick links:
Advertisement
Table of Contents
