Using Cableclear /Dnr (Digital Noise Reduction); Selecting The Color Temperature - Toshiba 56HM195 Owner's Manual

Adjusting the picture
®
Using CableClear
reduction)
®
The CableClear digital noise reduction feature allows you to
reduce visible interference in your TV picture. This may be
useful when receiving a broadcast with a weak signal (especially
a Cable channel) or playing a noisy video cassette or disc. This
feature is enabled for 480i signals only.
Note: The CableClear DNR feature does not function in
ColorStream, HDMI (DVI), ATSC, IEEE1394, and digital Cable
modes.
To select CableClear/DNR preferences:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
Video
Picture Settings
Advanced Picture Settings
Theater Settings
3. In the CableClear/DNR field, select your desired setting.
Advanced Picture Settings
Dynamic Contrast On
MPEG Noise Reduction Low
CableClear Auto
Cool
Color Temperature Cool
Lamp Mode Low Power
Reset Done
Note:
• If the current input is Antenna, Video 1, Video 2, or Video 3,
the menu will display the text CableClear. The available
selections are Off, Low, Middle, High, and Auto.
• If the current input is ColorStream HD1, ColorStream HD2 or
HDMI and the video resolution is 480i, the menu will display
the text "DNR. " The available selections are Off, Low, Middle,
High, and Auto. Auto will react proportionally to the strength
of the noise. Low, Middle, and High will reduce the noise in
varying degrees from lowest to highest, respectively.
• If the current input is ColorStream HD1, ColorStream HD2, or
HDMI, and the video resolution is not 480i, the menu will
display the text "DNR".
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
80
Chapter 8: Using the TV's features
(continued)
/DNR (digital noise
ANT 1
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

Selecting the color temperature

You can change the quality of the picture by selecting from three
preset color temperatures (cool, medium, and warm), as
described below.
Mode Picture Quality
cool blueish
medium neutral
warm reddish
To select the color temperature:
1. Press MENU and open the Video menu.
2. Highlight Advanced Picture Settings and press ENTER.
Video
Picture Settings
Advanced Picture Settings Advanced Picture Settings
Theater Settings
3. In the Color Temperature field, select the mode you prefer
(Cool, Medium, or Warm).
Advanced Picture Settings
Dynamic Contrast On
MPEG Noise Reduction Low
CableClear Auto
Cool
Color Temperature Cool
Lamp Mode Low Power
Reset Done
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Note:
If you select one of the factory-set picture modes (Sports,
Standard, or Movie) and then change the color temperature
mode, the picture mode automatically changes to Preference in
the Picture Settings menu.
ANT 1