Assembling the Kit
Assemble the kit as shown in
Figure 3
to determine which hole to use in the upper mount.
Note:
Do not overtighten the bolt (1/4 x 4-1/4 inches) and nut (1/4 inch); the hinge bracket must pivot freely.
Note:
Install the lower support bracket only if you are mounting the kit in front of the rear tires. Install the
bracket so that the large face is oriented rearward on the machine;
for mounting the kit on the left side of the machine.
1. Main bracket
2. Top bracket
3. Carriage bolt (5/16 x 7/8
inch)
Figure
2. Ensure to loosely install the upper mount to the main bracket; refer to
4. Welded support bracket
5. Nut (1/4 inch)
6. Hinge bracket
Figure 2
Figure 2
7. Bolt (1/4 x 4-1/4 inches)
8. Nut (5/16 inch)
9. Lower support bracket (if
needed)
3
shows the bracket orientation
10. Upper mount
11. Knob
g037080