Adding Channels To The Tv's Memory; Programming Channels Automatically - Toshiba 43H71 Owner's Manual

Adding channels to the TV's memory

When you press Channel yz, the TV will select only the channels
stored in the TV's channel memory.
Follow the steps below and on the next page to program all active
channels into the TV's memory.

Programming channels automatically

The TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels (see page 20).
To program channels automatically:
1. Press MENU, and then press x or • until the SET UP menu
appears.
2. Press y or z until TV/CABLE is highlighted.
3. Press x or • to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV; if you use
cable, highlight CABLE.
SET UP
LANGUAGE ENGL SH I
CLOCK SET 0 0 : 0 0
ANT 1 / 2 ANT1
TV / CABLE TV / CABLE
CH PROGRAM
ADD / ERASE ADD
4. Press z to select CH PROGRAM.
SET UP
LANGUAGE ENGL SH I
0 0 : 0 0
CLOCK SET
ANT 1 / 2 ANT1
TV / CABLE CABLE
CH PROGRAM
ADD / ERASE ADD
5. Press x or • to start automatic channel programming. The TV
will automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now—Please Wait" appears.
6. When channel programming is complete, the message
"Completed" appears.
7. Press Channel yz to view the programmed channels.
Note:
To tune the TV to a channel not programmed
in the channel memory, use the Channel
Number buttons on the remote control.
LIGHT RECALL POWER
TV
CABLE
MUTE TV/VIDEO TIMER
VCR
Channel yz
1 2 3
CH
4 5 6
Channel
7 8 9
Number
VOL
CH RTN
100 0
ENT
ADV/
PIP CH
MENU
MENU/
FAV FAV
ENTER
yzx •
ADV/
PIP CH
19