Adding Channels To The Tv's Memory - Toshiba COLORSTREAM 43A61 Owner's Manual

Adding channels to the TV's memory
When you press Channel • or V, your TV will stop only on the
channels stored in the TV's channel memory. Follow the steps below
and on the next page to program channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels and store them
in its memory. After the TV has stored the channels in its memory,
you can erase channels or add your favorite channels. If you use both
ANT-1 and ANT-2 terminals, you must program channels for each
input source.
To program channels automatically:
1. Press MENU, and then press • or • until the SET UP menu
appears.
2. Press • or • until TV/CABLE is highlighted.
3. Press • or • to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV; if you use
cable, highlight CABLE.
®@®®@®
O SET UP
LANGUAGE ENGLISH
CLOCK SET
CH PROGRAM
ADD/ERASE ADD
AT4
AV
4. Press • to select CH PROGRAM.
®@®®@®
O SET UP
LANGUAGE ENGLISH
CLOCK SET
ANT1/2 ANT1
5. Press • or • to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now--Please Wait" appears.
6. When channel programming is complete, the message
"Completed" appears.
7. Press Channel •• to view the programmed channels.