Changing The Battery - Schaudt Electrobloc EBL 208 S G Instruction Manual

Instruction Manual Electrobloc EBL 208 S G
Starting up the system
8
9

Changing the battery

Batteries may only be changed by qualified personnel.
▲
Follow the instructions of the battery manufacturer.
▲
To electrically disconnect the battery from the Electrobloc, all you need to
▲
do is set the battery cut-off switch on the Electrobloc to "Battery off", see
8 "Shutting down the system".
Charging unsuitable types of battery may irreparably damage them.
▲
Only use the Electrobloc for connecting the 12 V power supply to 6-cell
▲
lead gel or lead acid batteries.
Only use batteries of the same type and capacity and those installed by the
manufacturer.
You can change from lead acid to lead gel batteries.
You cannot change from lead gel to lead acid batteries. Ask your dealer for
advice.
There is a danger of explosion due to the formation of detonating gas if
▲
the battery selector switch is incorrectly set.
An incorrectly set battery selector switch damages the living area battery.
▲
Disconnect the Electrobloc from the mains before adjusting the battery
▲
selector switch.
The switching option provided by the battery selector switch ensures optimum
charging of the two different types of battery, lead acid and lead gel. The
switch must be set to the correct battery type: lead acid or lead gel.
❱ For a lead gel battery, set the battery selector switch to "Lead-Gel".
❱ For a lead acid battery, set the battery selector switch to "Lead-Acid".
❱ Set the battery cut-off switch on the Electrobloc to "Battery on".
❱ After having disconnected the living area battery from the Electrobloc
using the battery cut-off switch or after changing the battery, briefly switch
on the 12 V main switch on the control and switch panel to start up the con-
sumers.
Edition: 20.11.2018
R
8110600 BA / EN