Table of Contents
Advertisement
5
Drill
Tilt the drive until the drill bit is in line with the beam and ap-
pears centered in the outer ring. The drill bit will nearly fill
the locking hole image. Hold the drill firmly in this position
and drill through both cortices.
6
Measure
Instrument
357.402
Locking Bolt Measuring Device
Use the locking bolt measuring device to measure for locking
bolt/screw length. Read locking bolt/screw length directly
from the depth gauge.
Synthes
37
Advertisement
Table of Contents
Need help?
Do you have a question about the Titanium Trochanteric Fixation Nail System and is the answer not in the manual?