Polaris EV206PH-B Technical And Service Manual page 19

4. Use a phillips head screwdriver to remove all screws from the
control cover cap (4 total).
5. remove the left and right control cover cap sides (pay attention
to how cables are routed through control cover cap).
dUO drIVE mOTOr SErVICE
dUOdrIVE mOTOr SErVICE: Contact our customer service team. If it is determined that the throttle is the
source of an issue, follow the instructions below to easily replace the throttle.
rear Wheel motor removal
TOOLS rEQUIrEd: phillips head screwdriver, lug wrench
1. turn off the bike, and remove the battery.
2. press the power button on the display to purge stored energy.
3. remove the control box cover. you will need a phillips head
screwdriver (refer to controller cap removal/installation above).
4. locate the cables leading to the control box from the rear wheel
motor. there should be two wires.
5. disconnect the quick disconnect plugs on both cables.
6. Cut off the zip ties holding motor cable to rear fork of bicycle (be
careful not to cut cable).
32
Servicemanual_101212.indd 32-33
Screws
10. be careful to notice how the rear wheel interfaces with the chain
rear Wheel motor Installation
7. loosen the lug nuts on rear axle.
8 Unscrew the security latch holding down axle on both sides.
9. remove the wheel from the rear axle dropout.
and derailleur.
1. take the new wheel (completely unpacked per instructions in
the box) and loosen both axle bolts.
2. Slide into the rear axle dropout on the rear fork (being careful
to repeat exactly how the wheel interfaced with bike chain and
derailleur).
3. Secure and tighten the rear axle lugnuts on both sides.
33
10/12/2012 12:25:58 am