Toshiba AS311 User Manual page 26

Programmable controller ascii interface module

Hide thumbs Also See for AS311:

Table of Contents

4. Register Configuration

4.1 I/O allocation and I/O registers

The AS311 has the I/O type 'i X+Y 4W' for I/O allocation. When the automatic I/O

allocation is performed with mounting the AS311, the following I/O allocation table will

be created in the T3.

(T-PDS screen example - in the case that AS311 is mounted on Slot 0 of Unit 0)

Then, 4 I/O registers, XW(n), XW(n+1), YW(n+2) and YW(n+3), are assigned to the

AS311.

In the above example, XW000, XW001, YW002 and YW003 are assigned.

Note that the I/O type has 'i' designation. It means that the T3 will not update the

assigned I/O registers in the batch I/O processing. To read or write data through

the I/O registers, the Direct I/O instruction (FUN235) or the direct I/O designation

(I/IW and O/OW instead of X/XW and Y/YW) is necessary.

The reason of that is because the reading and writing timings are important for

handshaking between T3 and AS311. Refer to section 5.

ASCII Interface Module (AS311)

Table of Contents

Prosec t3