Table of Contents
Advertisement
At firth touch the appliance
proposes the default setting
of the washing programme
again.
7.10 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric creasing
and facilitates the fabric ironing.
The indicator
during steam phase.
This option can increase the
programme duration.
When the programme stops the display
shows a zero
steady on and the indicator
flashing. The drum performs smooth
movements for about 30 minutes to keep
the steam benefit. By touching any
8. SETTINGS
8.1 Acoustic signals
To deactivate the acoustic signals when
the programme is completed touch the
Startuitstel and the Extra Spoelen
buttons simultaneously for about 3
seconds.
The acoustic signals, they
continue operate when the
appliance has a malfunction.
8.2 Child Lock
With this option you can prevent that the
children play with the control panel.
• To activate/deactivate this option,
touch the Vlekken/Voorwas and the
Extra Spoelen buttons simultaneously
until the indicator
off on the display.
You can activate this option:
• After you touch the Start/Pauze
button: all the buttons and the
programme dial are deactivated
(except Aan/Uit button ).
flashes on the display
, the indicator
is
starts
comes on/goes
button the anti-crease movements stop
and the lid unlocks.
A small laundry load helps to
reach better results.
7.11 Startuitstel
With this option you can delay the start
of a programme in a more convenient
time.
Touch the button repeatedly to set the
required delay. The time increases by
steps of 30 minutes up to 90' and from 2
hours up to 20 h.
After touching the Start/Pauze button,
the display shows the indicator
the selected delay time and the
appliance begins the countdown.
7.12 Start/Pauze
Touch the Start/Pauze button to start,
pause the appliance or interrupt a
running programme.
• Before you touch the Start/Pauze
button: the appliance cannot start.
The appliance keeps the selection of this
option after you switch it off.
8.3 Soft Plus
Set the Soft Plus option to optimise the
fabric softener distribution and improve
the fabric softness.
It is suggested when you use the fabric
softener.
This option increases slightly
the programme duration.
To activate/deactivate this option touch
the Temp. °C button and the TPM.
button simultaneously until the
indicator comes on/goes off above the
indicator.
8.4 Permanent Extra Rinse
With this option you can permanently
have an extra rinse when you set a
programme where it is selectable.
ENGLISH
17
and
Advertisement
Table of Contents
