16. ACCESSORIES......................38 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
If a tumble dryer is stacked on the top of the washing • machine, make sure to use the correct stacking kit approved by AEG (see more details in chapter "Accessories - Stacking kit"). 2. SAFETY INSTRUCTIONS 2.1 Installation •...
Page 5
ENGLISH • Adjust the feet to have the necessary • Ensure that there are no visible water space between the appliance and the leaks during and after the first use of flooring. the appliance. • Do not install the appliance where the •...
• Remove the door catch to prevent for the disposal of Waste Electrical children or pets from becoming and Electronic Equipment (WEEE). trapped in the drum. • Dispose of the appliance in accordance with local requirements 3. INSTALLATION WARNING! Refer to Safety chapters.
Page 7
ENGLISH Make sure not to damage the hoses. • A (FRONT) = Front of the appliance 7. Remove the polystyrene protection • B (BACK) = Rear of the appliance from the bottom. 10. Remove the adhesive strip from the silent barriers. 11.
Page 8
To limit vibration we recommend placing a waterproof wooden panel, at least 15 mm thick, under the appliance. It should be screwed to at least 2 floor beams and should extend beyond the front feet. If possible, install the appliance where the floor is more stable.
Page 9
ENGLISH When the machine is installed on a plinth or if a washer dryer is stacked on the washing machine, use the accessories described in chapter 'Accessories'. Read carefully the instructions supplied with the appliance and with the accessory. CAUTION! Make sure that there are no leaks from the couplings.
5. Without the plastic hose guide, to a sink spigot - Put the drain hose in Make sure that the drain the spigot and tighten it with a hose end is not immersed in clamp. Refer to the illustration.
Page 11
ENGLISH The washing programme is tailored to the fibres and reduces fabric creasing. the laundry load and the type of fabric Ironing will be easier! without consuming more time, energy • The Stains option pre-treats stubborn and water than necessary. stains optimizing the effectiveness of •...
5. CONTROL PANEL 5.1 Control panel description 11 10 Programme dial Extra rinse touch button (Extra Rinse) Display Delay start touch button (Delay Start) Energy saving touch button (Eco) Super steam touch button (Plus Time saving touch button (Time...
Page 13
ENGLISH 5.2 Display Maximum load indicator. The icon flashes during laundry load esti- mation (refer to "PROSENSE load detection" paragraph). Maximum laundry indicator. It flashes when the laundry load exceeds the maximum declared load of the selected programme. Delay start indicator. Door locked indicator.
Time saving indicator. Temperature indicator. The indicator appears when a cold wash is set. Spin speed indicator. Rinse hold indicator. Quiet indicator. Pre-wash indicator. Stain indicator. Extra rinse indicator. 6. DIAL AND BUTTONS 6.1 On/Off 6.3 Temp. Pressing this button for a few seconds...
Page 15
ENGLISH The drum turns regularly to reduce This option is not creasing. available with a The door stays locked. The drum temperature lower than turns regularly to reduce creasing. 40 °C. You must drain the water to unlock • Prewash the door.
Page 16
When the programme stops the display This option can also be used shows a zero , the indicator to shorten the Steam programme duration. steady on and the indicator starts flashing. The drum performs smooth 6.10 Skipping phase button movements for about 30 minutes to keep the steam benefit.
ENGLISH 7. PROGRAMMES 7.1 Programme Chart Washing programmes Programme Programme description Washing programmes White cotton and coloured cotton. Normal, heavy and light soil. Cottons Standard programmes for the Energy Label consumption values. According to regulation 1061/2010, the programme Cottons at 60 °C and the programme Cottons at 40 °C with the option are respectively the «Standard 60°C cotton pro- gramme»...
Page 18
Programme Programme description Cotton and fast-coloured synthetic items. Complete washing programme that, in only 59 minutes, washes the daily soiled OKOPower laundry intensively and ensures a good washing performance in a short time. White cotton items. This programme removes micro-organ-...
Page 19
ENGLISH Programme temperature, maximum spin speed and maximum load Programme Default temperature Maximum spin speed Maximum load Temperature range Spin speed range Cottons 40 °C 1400 rpm 8 kg 95 °C - Cold 1400 rpm - 400 rpm 40 °C 1200 rpm 3 kg 60 °C - Cold...
ENGLISH 8. BEFORE FIRST USE 1. Make sure that all transit bolts have 5. Set and start a programme for cotton been removed from the appliance. at the highest temperature without 2. Make sure that the electrical power is any laundry in the drum. available and the water tap is open.
10. DAILY USE 10.3 Filling the detergent and WARNING! additives Refer to Safety chapters. 10.1 Activating the appliance 1. Connect the mains plug to the mains socket. 2. Open the water tap. 3. Press the On/Off button for a few seconds to activate the appliance.
Page 23
ENGLISH 2. Press the lever down to remove the With the flap in the dispenser. position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on the flap. •...
Page 24
Changing the delay start after In case a selection is not possible, no indicator comes the countdown has started on and an acoustic signal To change the delay start: sounds. 1. Touch the Start/Pause button to 10.6 Starting a programme pause the appliance.
Page 25
ENGLISH 10.10 Interrupting a this case, it will be not possible to guarantee the best washing results. programme and changing the options About 20 minutes after the programme start, the When the programme is running, you programme duration could can change only some options: be adjusted again depending on the capacity 1.
Page 26
In the display the related door lock • The display shows the indicator , the indicator goes off. option indicator and the 2. Open the appliance door. If necessary, add or remove the items. door locked indicator . The 3.
ENGLISH If you set a programme or an option that ends with water in the drum, the Stand-by function doesn't deactivate the appliance to remind you to drain the water. 11. HINTS AND TIPS 11.2 Stubborn stains WARNING! Refer to Safety chapters. For some stains, water and detergent is not sufficient.
11.4 Ecological hints 11.5 Water hardness • Set a programme without the If the water hardness in your area is high prewash phase to wash laundry with or moderate, we recommend that you normal soil. use a water softener for washing •...
Page 29
ENGLISH 12.5 Cleaning the drum Regularly examine the drum to prevent rust forming. For a complete cleaning: 1. Clean the drum with special products for stainless steel. Always follow the instructions that you find on the packaging of the product. 3.
Page 30
Clean the drain pump if: without removing. Let the water flow • The appliance does not drain the out. water. • The drum does not turn. • The appliance makes an unusual noise because of the blockage of the drain pump.
Page 31
ENGLISH 12.8 Cleaning the inlet hose 10. Clean the filter under the water tap. and the valve filter It is recommended to clean both the filters of the inlet hose and valve occasionally to remove any deposit, collected over the time: 1.
12.10 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket.
Page 33
ENGLISH The programme was not finished properly or the appliance stopped too early. If the alarm code appears again, contact the Authorised Service Centre. • - The anti-flood device is on. Disconnect the appliance and close the water tap. Contact the Authorised Service Centre.
Page 34
Problem Possible solution • Make sure that the sink spigot is not clogged. • Make sure that the drain hose has no kinks or bends. • Make sure that the drain filter is not clogged. Clean the fil- ter, if necessary. Refer to "Care and cleaning".
Page 35
ENGLISH Problem Possible solution • Increase the detergent quantity or use a different deter- gent. The washing results are • Use special products to remove the stubborn stains before not satisfactory. you wash the laundry. • Make sure that you set the correct temperature. •...
5. Take out the laundry and then close the appliance door. 6. Close the filter flap. 14. CONSUMPTION VALUES Stated values are obtained in laboratory conditions with relevant stand- ards. Different causes can change the data: the quantity and type of laundry and ambient temperature.
ENGLISH Programmes Load Energy Water Approxi- Remain- (kg) consump- consump- mate pro- ing mois- tion (kWh) tion (litre) gramme ture (%) duration (minutes) 0.34 Standard 40°C cotton 1) At the end of spin phase. Off Mode (W) 0.30 Left On Mode (W) 0.30 The information given in the chart above is compliant with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC .
The tumble dryer can be stacked on the top of the washing machine only by www.aeg.com/shop or from using the correct stacking kit authorised dealer manufactured and approved by AEG. Only appropriate Verify the compatible accessories approved by stacking kit by checking the AEG ensure the safety depth of your appliances.