Table of Contents
Advertisement
Operation
IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE PLACED ON THIS
HEATER.
Before using the heater ensure that all warnings and instructions have been
read carefully. To begin using the heater simply plug it in to a corresponding
power outlet.
1. Turn on the main power switch at the back of the unit to the 'I' position.
The unit will beep once to indicate it is powered and in standby mode. The
LED display will illuminate and indicate the current room temperature.
2. Press the On/Off button to turn the unit ON.
3. Press the POWER button once to operate in low power (1200W) or twice
to operate in high power (2000W). The corresponding low and high power
indicator light will illuminate on the control panel.
4. A TIMER can be set up to 12 hours, so the unit turns OFF automatically
after a set period. Press the TIMER button and cycle through, in 1 hour
increments, the desired time. The set time will flash on the LED Display. To
cancel the TIMER, cycle through until '0' shows on the display.
5. To adjust the room temperature, set the desired temperature between
10-35°C. The temperature is set in 1°C increments and will flash on the
LED display until selected. The unit will automatically work to reach and
maintain the set temperature,
6. The unit is equipped with an oscillating base. To activate, press the
OSCILLATION button. Press again to cancel.
7. Press the power On/Off button to turn the unit OFF. It takes approx. 30
seconds for the unit to power OFF, this is to protect the heating element.
8. If the unit isn't being used for an extended period of time, switch the main
power switch to '0' (after the unit has turned OFF completely which takes
approx. 30-60 seconds).
8
Advertisement
Table of Contents
