Operation - Dimplex DHPH20F Instruction Manual

Operation

Note: Before plugging in for use, ensure the thermostat is set anti-clockwise to the
MIN setting, and the heater switch is set to OFF.
1. Rotate the thermostat completely clockwise, until it reaches the MAX position.
2. To turn on the heating function, set the controls to your desired heat setting,
either LOW HEAT or HIGH HEAT. An indicator light will illuminate, showing that
the heater is on.
3. When your room reaches the desired temperature, slowly rotate the
THERMOSTAT anti-clockwise until you hear a click. The THERMOSTAT can now
be left at this setting. As soon as the room temperature has dropped below
the set temperature , the unit will switch itself on automatically until the set
temperature has been reached again. This allows the room temperature to remain
constant and perform economically.
4. To change the room temperature setting, rotate the thermostat clockwise to raise
the temperature, and anti-clockwise to lower it.
5. To switch the heater off, set the THERMOSTAT to MIN and the control to OFF.
Then switch the power off at the mains and remove the plug from the outlet.
8
Max
Min