Advertisement
NOTE: When installing the gas spring, be sure
that the body of the gas spring is secured on the
top.
10. Secure the two machine screws (installed in step 2)
(A) retaining the grab catch support to the wind-
shield frame. See Fig. 10.
Fig. 10
11. Raise the window of the windshield. Mark the
holes for the grab catch support on top of the dash-
board Remove grab catch support and drill both
holes using a 3/8-in. drill bit; then insert both Rub-
ber Well-Nuts. Secure the grab catch support using
two machine screws (A) into the rubber well-nuts
and the two machine screws from figure 10.
CAUTION
When drilling through the dash, be sure of what is
on the other side.
12. Lower the window and lock in position using the
locking grab handle. Check that the seal is in con-
tact with the surface of the windshield frame. Note
the position of the grab catch, raising the window
and tighten the two machine screws (C) holding the
grab catch (B) to grab catch support. See Fig. 11.
Fig. 11
13. Reinstall the roof using the existing hardware
removed in step 3.
Printed in the U.S.A.
®™Trademarks of Arctic Cat Inc., Thief River Falls, MN 56701
14. Fasten the upper part of the windshield onto the
roof using five machine screws (M6-1.0 X 25 mm)
(C), five lock washers (B), and five flat washers
(A) included in the Roof Kit (p/n 1436-500). See
Fig. 12.
Fig. 12
NOTE: Install cab components in this sequence.
UTV-166A
Windshield, rear panel, roof, and then door kit. If
you have already installed some cab components
and are adding, it may be necessary to remove
installed components. See Fig. 13.
Fig. 13
UTV-168A
3
UTV-154A
0511
Advertisement
