Advertisement
4. If you plan to proceed with the installation of the
Roof Kit (p/n 1436-500) or it will be mounted on
your vehicle at this time, apply Self-Adhesive
Foam (A) on top of the windshield. If not, keep it
for future installation.
Fig. 4
5. Position the windshield assembly on front of the
ROPS tubes. See Fig. 5.
Fig. 5
6. Fasten the upper part of the windshield assembly onto
the front horizontal tube of the ROPS using two C-
clamps (D), two machine screws (M6-1.0 X 25 mm)
(A), fender washers (B), two rubber washers (C), and
flange nylock nuts (M6-1.0) (E) (finger tighten at this
time). See Fig. 6.
Fig. 6
7. Fasten the lower part of the windshield assembly onto
the front vertical tubes of the ROPS using two C-clamps
(A), two machine screws (M6-1.0 X 20 mm) (C), and
two fender washers (B) (finger tighten at this time). See
Fig. 7.
Fig. 7
8. Make sure that the upper part of the windshield
UTV-157A
assembly is well supported on the ROPS. If the
bottom frame is not well supported against the
ROPS, loosen the four machine screws (two on
each side) connecting the side main frames to the
lower main frame. Adjust and tighten the four
machine screws (see Fig. 8). Tighten all machine
screws attaching the C-clamps installed in steps 6
and 7.
Fig. 8
UTV-163
9. Insert the ends of the gas spring (A) into the holes
on the windshield frame and secure using the two
nylock nuts (M8-1.25) (B). Repeat step for the
opposite side. See Fig. 9.
Fig. 9
UTV-164A
2
UTV-165A
UTV-167
UTV-169A
Advertisement
