These screws are not included. Choose them based on your ceiling structure. Leave at least a 4 mm gap between ceiling mounting kit and false ceiling to prevent vibration noises. VTR 200 Ceiling mounting kit Installation instructions Systemair Sverige AB 210647...
(3) to mount ceiling mounting kit on threaded rods. Leave at least a 4 mm gap between ceiling mounting kit and false ceiling to prevent vibration noises. VTR 200 Ceiling mounting kit Installation instructions Systemair Sverige AB 210647...
Use included screws (C). Leave at least a 4 mm gap between ceiling mounting kit and false ceiling to prevent vibration noises. VTR 200 Ceiling mounting kit Installation instructions Systemair Sverige AB 210647...
The cabling on the top of the unit have to be led through a hole in the ceiling mounting kit. Then lift the unit and press it to the ceiling mounting kit. VTR 200 Ceiling mounting kit Installation instructions Systemair Sverige AB 210647...
Page 8
Lock hooks (X) should go through brackets. Pull out the lock mechanism (Y) if needed. Screw the locking mechanism on both sides using the screws (A) and washers (B). VTR 200 Ceiling mounting kit Installation instructions Systemair Sverige AB 210647...
Page 9
Systemair Sverige AB reserves the right to make changes and improvements to the contents of this manual without prior notice. Systemair UAB Linų st. 101 LT–20174 Ukmergė, LITHUANIA Phone +370 340 60165 Fax +370 340 60166 www.systemair.com...