Table of Contents
Advertisement
5 Mechanical Installation (Assembly)
5. Prerequisites
The substructure must be:
• even,
• vibration-free, and
• torsionally stiff
NOTICE
The connecting line is not trailing capable.
5. Installation on substructure
NOTICE
Use only the pre-established boreholes for the installation on the substructure. Additional
boreholes at different positions are not allowed!
Fastening the device on the substructure requires three M4 screws (not supplied).
Bore holes for mounting screws
To install the unit on the substructure, proceed as follows:
1. Copy the borehole diagram (see the corresponding figure for the installation dimensions)
onto the substructure.
• The installation of the podis MOT on the substructure is carried out according to local
conditions in accordance with the borehole diagram.
2. Fasten the podis MOT on the substructure using at least two M4 screws.
• Observe the alignment according to the planned routing of the podis flat cable.
• The podis MOT is installed on the substructure.
• The mechanical installation is complete, the electrical installation may be started next.
Wieland Electric | BA000341 | 02.2007
5 | Mechanical Installation (Assembly)
Procedure
Procedure
5.
Advertisement
Table of Contents
