Podis ® Mot Fa C IO/I3O Device Description; General - Wieland podis?MOT FA C 3I/1I4O Operating Instructions Manual

3 podis MOT FA C IO/I3O Device Description
®

3. General

The field distributor podis MOT FA C 2I1O/1I3O is an AS-i sensor / actuator module on the
podis energy bus for the control and energy supply of decentral drives with binary control.
®
podis MOT FA C IO/I3O
The connection between field distributor and drive is implemented using a prefabricated
connecting line.
Using prefabricated M12 connecting lines allows for connecting 2-wire and 3-wire sen-
sors to the two free inputs. The sensors are supplied in the podis field distributor from the AS
interface. The output via M12 is an electronic output with a maximum load of 24 VDC and 0.5
A. This A0 output is available at M12 as well as PIN 6 of the connector interface.
The field distributor is directly connected to the AS-i hand-held terminal (83.209.2204.0) and
addressed using the AS-i programming cable (83.209.2205.0).
To display the current switching state and the status of the inputs, each channel features an
LED in the housing cover of the field distributor.
The connection to the AS-i transmission line is carried out via M12 connecting plug. If a
separate AS-i flat cable is used, the AS-i tap line and the AS-i adapter are required.
The contact to the energy bus is established via penetrating screws.
Wieland Electric | BA000341 | 02.2007
3 | podis MOT FA C IO/I3O Device Description
®
3.