Advertisement
Connection to the Amplifier
This turntable uses a moving magnetic cartridge. Set the PHONO & Line
Out Switch on PHONO mode. Connect the phono out cables to the phono
input on your amplifier of pre-amplifier (phono stage). Line inputs such as
CD, Tuner, Tape, or Video are not suitable for phono inputs. Make sure
the amplification of the selected input matches the type of cartridge being
used. The factory installed cartridge is 47k ohms/MM-input.
NOTE: If your amplifier does not have an input suitable for phono cartridges,
you will need to purchase a separate phono amplifier for moving magnetic
cartridges. This separate phono amplifier will then connect between your
turntable and your amplifier.
Stereo System Connection
Set the PHONO & Line Out Switch on LINE mode. The RCA PHONO &
Line Out Jacks output analog line-level signals and could be connected
directly with a par of active/powered speakers of the appropriate input of
your stereo system.
The Red plug connects with the Right channel and the White plug connects
with the Left channel.
NOTE: The RCA Jacks are not designed to be connected directly to the
passive/unpowered speakers on LINE mode. If connected to the passive
speakers, there is no sound.
Main Power Connection
The power adaptor is in the foam packing material. Unpack the power
adaptor and plug the small end into the DC power jack located at the back
side of the turntable. Plug the power adaptor into your power outlet.
10
Advertisement
