Table of Contents
Advertisement
(2)
Replacing the hook and tightening the screws.
Install securely the hook in the groove of power tool and
tighten the screws to fi x the hook fi rmly. (Fig. 13)
5.
Remaining battery indicator
You can check the battery's remaining capacity
by pressing the remaining battery indicator
switch to light the indicator lamp. (Fig. 14,
Table 4)
The indicator will shut off approximately 3
seconds after the remaining battery indicator
switch is pressed.
It is best to use the remaining battery indicator
as a guide since there are slight diff erences
such as ambient temperature and the condition
of the battery.
Also, the remaining battery indicator may vary
from those equipped to a tool or charger.
State of lamp
As the remaining battery indicator shows somewhat diff erently depending on ambient
temperature and battery characteristics, read it as a reference.
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50% – 75%.
Lights ;
The battery remaining power is 25% – 50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty. Recharge the battery
soonest possible.
Blinks ;
Output suspended due to high temperature. Remove the battery from the
tool and allow it to fully cool down.
Blinks ;
Output suspended due to failure or malfunction. The problem may be the
battery so please contact your dealer.
Groove
Remaining battery
indicator lamp
Display panel
Table 4
Battery Remaining Power
41
English
Hook
Fig. 13
Remaining battery
indicator switch
Fig. 14
Screw
Advertisement
Chapters
Table of Contents
