Table of Contents
Advertisement
(2)
Insert the pin into the socket. (Fig. 7)
(3)
While making sure that the pin doesn't fall, attach the O-ring to the groove on the socket.
(Fig. 8, 9)
Fig. 8
CAUTION
○
Please use the designated attachments which are listed in the operations manual
and Hitachi's catalog. Accidents or injuries could result from not doing so.
○
Make sure to fi rmly install the socket in the anvil. If the socket is not fi rmly
installed it might come out and cause injuries.
○
When sliding the O-ring out of the groove of the socket, be careful not to drop and
lose the pin.
○
It is possible to temporarily hold the socket in place with the friction ring, but be
sure to insert the pin and attach the O-ring before use.
If the power tool is used while the socket is temporarily held in place, the socket
may fall off and cause an injury.
HOW TO USE
1.
Check the rotational direction
The bit rotates clockwise (viewed from the rear
side) by pushing the R-side of the pushing button.
The L-side of the pushing button is pushed to turn
the bit counterclockwise. (See Fig. 10). (The
and
marks are engraved on the body.)
Friction ring
Groove
Hexagonal
Hole
socket
Push
39
Fig. 7
Hole of anvil
Anvil
Fig. 9
Pushing button
marks
Trigger switch
Fig. 10
English
Pin
Push
marks
Advertisement
Chapters
Table of Contents
