C300 MKII Setup
Front Bulkhead, Port and Port Ring
Inspection. Before installing the Port Base, Port Ring and Port, visually inspect the
o-rings for dirt or other foreign matter that may compromise the seals. Do the same
with the Front Shell face (where the Front Bulkhead mates) and Port bore where the
o-rings seal. See the separate document "Housing Care and Maintenance
Guide" for more details.
NOTE: Some lenses do not require a Port Ring. Refer to Gates Lens Compatibility
Matrix for details.
CAUTION: Do Not lubricate the ORANGE Front Bulkhead o-ring. It is silicone
material and lubricant may cause damage. Only the BLACK and YELLOW o-rings
are safe to lubricate.
Install the Port Base. Position the Port Base over the entire lens / LGD's and
secure to the front bulkhead with 4 screws. Tighten the 4 screws firmly.
Page 25
Install Front Bulkhead with
4 screws and washers.
Tighten firmly.