Advertisement
SAM ELECTRONIC EQUIPMENT (HK) LIMITED
2： ： ： ： Position the foot-switch at a location for easy operation
3． ． ． ． 6． ． ． ． 2： ： ： ： SM-2008 Operating procedures
1： ： ： ：
Turn on the power, the light at "0" button starts to blink. Regardless of the top
cutter's position, press "0" button and the light becomes on all the time. Now
step on the foot-switch.
Hold on the foot-switch till the light at "0" button starts to blink again and the
top cutter moves to Home location, then release the foot-switch.
2： ： ： ：
Select cutter travelling distance according to the length of PCB for cutting.
There are scales (0,100,200,300,400),"length" button and "speed" button on the
front
cover.
Example for length setting:
a) Set cutter travelling distance from 0 to 100
b) Push the button at scale "100"
c) Lamps at "0" button and "100" button light up
d) Step on the foot-switch till the top cutter travelled to "100" position and
stopped.
e) The cutter will travel back to "0" position when the foot-switch is released.
f) After this setting, the top cutter will travel between 0 and 100.
Note:Kick the kick starter till the up cutter move to "100" then release the kick
starter.The up cutter will home to "0" when re-kick the kick starter.Then the up
cutter will run between|"0"and "100"
4： ： ： ：
Cutter selection, Standard of adjustment and Machine maintenance
Address: Room1701,17/F,HenanBuilding, NO.90-92JaffeRoad,Wanchai,HongKong
TEL:00852-58042046
FAX：00852-31158812
www.china-sam.com
- 9 -
Advertisement
