Advertisement
SAM ELECTRONIC EQUIPMENT (HK) LIMITED
Check the fuse box and see whether the fuse has been burnt off.
Replace a new fuse if necessary.
1． ． ． ． The power socket on the main power supply is used as secondary power supply for the
conveyor belt if it is chose as an option.
3． ． ． ． 5． ． ． ． Gap adjustment for top and bottom cutters
Adjust the cutters distance according to PCB thickness and material.
In order to prevent clashing between top and bottom cutters, it is necessary to
check and adjust the cutters so as to ensure that the gap in between is optimum
for the type and thickness of PCB under consideration.
Adjustment is achievable by tuning the clutch attached to the machine.
1, Move the up cutter fixture to easy adjustment.
2， ， ， ， There is a dial on the top cutter fixture 1, the scale is 0.1mm
Make sure that the top cutter is raised to scale "16" when moving the
machine.
3， ， ， ， Hold knob 19 tightly and release the knob
Turn knob 18 till the pointer reaches "16" on the scale.
Hold knob 18 firmly and tighten knob 19 to secure the top cutter.
3.6 Operating Instruction
3． ． ． ． 6． ． ． ． 1： ： ： ： Preparation before operating the machine
1： ： ： ： Check for power and foot-switch connection and emergency switch is at a
designated location.
Address: Room1701,17/F,HenanBuilding, NO.90-92JaffeRoad,Wanchai,HongKong
TEL:00852-58042046
FAX：00852-31158812
www.china-sam.com
- 8 -
18
1
19
Advertisement
