Advertisement
Quick Links
LED Remote Phosphor Linear High Bay and Low Bay Lighting
1. INTRODUCTION
Advanced LED Remote Phosphor (LRP) lighting provides superior efficacy, reduced glare, and even lighting output.
These lighting products are designed for indoor facility lighting, ranging from 15'-60' ceilings, such as industrial or
retail applications. A wide variety of lighting options, along with the LRP series' glass-free, long lifetime, dimmable
design, make it a great lighting solution in many different setting
Precautions
WARNING
Risk of electrical shock. Disconnect power before servicing or installing product.
Risque de choc électrique. Coupez l'alimentation avant l'entretien ou l'installation du produit.
WARNING
Risk of injury or damage. Unit will fall if not installed properly. Follow installation instructions.
Risque de blessures ou de dommages. Unité va tomber s'il n'est pas installé correctement. Suivez les instructions
d'installation.
CAUTION
Risk of injury. Wear safety glasses and gloves during installation and servicing.
Risque de blessure. Porter des lunettes de sécurité et des gants lors de l'installation et de l'entretien.
This luminaire is designed to be used in ambient temperatures of -40C to +45C (-40F to +113F) and be
mounted horizontally with the light source down as shown above. This luminaire should be installed
indoors. It should not be mounted in wet locations in which water can drip, splash, or flow into the
luminaire.
6/20/2014
No part of this publication may be reproduced without the prior agreement and written permission of Horner Lighting Group, LLC. Information in this document is subject to change without notice.
ETG-LRP
LMAN0009-03-EN
ETG-LRP INSTALL SHEET
Page 1 of 5
Advertisement
Related Manuals for HORNER ETG-LRP Series
Summary of Contents for HORNER ETG-LRP Series
- Page 1 It should not be mounted in wet locations in which water can drip, splash, or flow into the luminaire. Page 1 of 5 6/20/2014 No part of this publication may be reproduced without the prior agreement and written permission of Horner Lighting Group, LLC. Information in this document is subject to change without notice.
-
Page 2: Getting Started
5) Using a leveling tool, adjust the cable length at the Locking Mechanism to level the fixture horizontally. Page 2 of 5 6/20/2014 No part of this publication may be reproduced without the prior agreement and written permission of Horner Lighting Group, LLC. Information in this document is subject to change without notice. - Page 3 3) Gently slide outside edge down so that the reflector tab going into the fixture becomes flush against the housing. Page 3 of 5 6/20/2014 No part of this publication may be reproduced without the prior agreement and written permission of Horner Lighting Group, LLC. Information in this document is subject to change without notice.
- Page 4 DIM + White DIM - Page 4 of 5 6/20/2014 No part of this publication may be reproduced without the prior agreement and written permission of Horner Lighting Group, LLC. Information in this document is subject to change without notice.
-
Page 5: Technical Support
Fax: 317 639-4279 Web: http://www.hornerlighting.com Email: techsppt@HornerETG.com Page 5 of 5 6/20/2014 No part of this publication may be reproduced without the prior agreement and written permission of Horner Lighting Group, LLC. Information in this document is subject to change without notice.