Advertisement
3.2 Reflectors
1) Obtain pair of reflectors for each tube.
2) Slide flat edge of reflector into slot on the light housing (heat sink) with reflective side facing
down.
3) Gently slide outside edge down so that the reflector tab going into the fixture becomes flush
against the housing.
6/20/2014
No part of this publication may be reproduced without the prior agreement and written permission of Horner Lighting Group, LLC. Information in this document is subject to change without notice.
LMAN0009-03-EN
ETG-LRP INSTALL SHEET
Page 3 of 5
Advertisement
