HORNER ETG-B100 Installation Manual

1. INTRODUCTION
Advanced LED remote phosphor indoor/outdoor lighting provides superior efficacy, reduced glare, and
even lighting output. The unique wing design of the B-200 allows adjustment of the spread patterns on
the two lighting modules.
Before you Begin
Read these instructions completely and carefully
Save these instructions for further use.
WARNING
Risk of electrical shock. Disconnect power before servicing or installing product.
WARNING
Risk of injury or damage. Unit will fall if not installed properly. Follow installation instructions
CAUTION
Risk of injury. Wear safety glasses and gloves during installation and servicing.
This luminaire is designed to be used in ambient temperatures of -40C to +45C (-40F to +113F) and be
mounted horizontally with the light source down as shown above. This luminaire is UL1598 Damp
Location Rated and should be installed indoors or in partially protected outdoor settings, such as
overhangs. It should not be mounted in wet locations in which water can drip, splash, or flow into the
luminaire.
10/25/2013
No part of this publication may be reproduced without the prior agreement and written permission of Horner Lighting Group, LLC. Information in this document is subject to change without notice.
ETG-B100 & ETG-B200
LED Remote Phosphor Indoor/Outdoor Lighting
Installation Guide
LMAN0007-01-EN
ETG-B100/B200 INSTALL SHEET
.
Page 1 of 3