Making Hot Water - Gaggia 10002533 Operating Instructions Manual

ENGLISH
perature. Otherwise, espresso may taste "burned".
Warning! If coffee is brewed without
reducing the temperature through water
dispensing, you may get burnt!
To do this: place an empty cup on drip plate.
Do not insert fi lter holder.
Press the manual supply button (2) and let water fi ll the
cup.
Press the button (2) again.
You many now proceed to make more espresso.

Making hot water:

Caution! Scalding hazard! Splashing may occur
at the start – scalding hazard! The hot water
nozzle and pipe can reach high temperatures:
avoid touching it directly with your hands.
1. Follow the procedure described under "Preparation".
2. Press the power switch (1).
3. Allow about 6 minutes for the machine to reach its proper
operating temperature.
4. Place a pitcher under the steam nozzle (6).
5. Slowly turn the steam knob (24) counterclockwise.
6. Press the hot water supply button (2) to allow the sup-
ply.
7. After obtaining the desired quantity of hot water, press
button (2) again, close the steam knob (24) by turning
it anticlockwise. Then remove the container.
N.B.: A max.supply of 40 seconds is recommended.
Keeping it clean:
1 IMPORTANT: the steam nozzle should be cleaned after
each use in order to avoid build up of milk deposits that
are very diffi cult to clean. Cleaning is made easy as can
be seen in the DESCRIPTION OF PARTS. The outer
part of nozzle can be removd by pulling downward.
The outside of the steam pipe can be cleaned with a damp
cloth.
The steam jet is cleaned by running a shot of steam
through it.
The hole in the steam nozzle must be kept open. A needle
may be used.
2 Clean fi lter holder and fi lter in warm water after use.
3 Wipe body of machine with a damp cloth as required.
4 Remove drip tray and plate (11-22) and wash in warm
soapy water. Do not use abrasive substances.
5 Clean the seal (14) inside of the brewing head (13) and
keep it clean.
6 The shower disc (16) should be unscrewed and cleaned
periodically depending on frequency of use.
7 If the machine is not used for long periods, discharge the
water from the boiler by turning the steam knob (24)
counterclockwise, and press the manual dispensing /hot
water button (2) and the steam button (3). Discharge
from the frother a quantity of water equal to two cap-
puccino cups. Close the steam knob (24) and press the
manual dispensing/hot water button (2) and the steam
• 16 •
Pay attention as the Turbo-Frother
steam nozzle could be hot!
Air intake to be kept clean and
free from residues.