Table of Contents
Advertisement
GUIDE MESSAGE THAT APPEARS
out of service (xx)
restart to fix...
close coffee bean lid
fill container wth coffee
insert the brew group
insert grounds drawer
empty grounds
empty grounds drawer
close door
fill the water tank.
empty drip tray
change the filter
carafe missing
milk island missing
descale
stand-by...
HOW TO REMOVE THE MESSAGE
(XX) identifi es an error code.Turn off and after 30 seconds turn
the machine on again to restore normal operation.If the problem
persists, call Saeco or an authorized service center and give the
code (xx) shown on the display.
Close the coffee bean hopper lid to be able to make a beverage.
Put coffee beans into the bean hopper.
Insert the brew group in its place (see page 26).
Insert the dregdrawer.
This preliminary warning does not stop the machine from
functioning. Proceed until the next message appears.
Remove the dregdrawer and dispose of the used coffee grounds
(see page 27 steps 1 and 2).
Note: The dregdrawer must be emptied only when the
machine requires it and when the machine is turned on. If
you empty the drawer with the machine turned off it will not
reset the count of cycles.
In order for the machine to operate, the side service door must
be closed.
The tank must be removed and refi lled with fresh drinking water.
Open the side service door and empty the drip tray located
under the brew group.
WARNING: WHENEVER THIS MESSAGE APPEARS, BE
SURE TO EMPTY THE DREGDRAWER AS WELL.
The water fi lter must be replaced in the following cases:
1. 60 liters of water have been dispensed;
2. 60 days have passed since its installation;
3. 20 days have passed after the machine's last use.
Note: this message only appears when the fi lter alarm function
has been set to "on" (see page 21, menu 2.4).
The steam knob has been turned to the
the Milk Island has not been installed or the carafe is not
positioned correctly. Install the Milk Island or position the carafe
correctly.
Otherwise, turn the knob until it is in the rest position ( ).
A descaling cycle must be performed on the machine's internal
circuits (see page 22).
Press the
button.
ERROR CODES
position and either
29
Advertisement
Table of Contents
